(root) / Modules / H_Bridge

3 phase bridge

2x H-bridge 2V - 11V

H-bridge-based ICs DRV8835HB. Allows you to control two DC motors in the range voltage 2V to 11V and maximum current of 1.5 A on the engine, or parallel, where it is then possible to control the 3A engine. Or the module can be used to control a stepper motor.

2x H-bridge 2V - 11V

H-bridge-based ICs DRV8835HB. Allows you to control two DC motors in the range voltage 2V to 11V and maximum current of 1.5 A on the engine, or parallel, where it is then possible to control the 3A engine. Or the module can be used to control a stepper motor.

Very high power bridge

Power bridge for 50V and 80A.

FET Bridge

Malfunction construction.

Middle power H-bridge

Middle power H-bridge

Middle power H-bridge

H-bridge

Full bridge 6-45 V max 3.6A for DC motors. It uses circuit DRV8871.

Replaced HBSTEP01B

Stepper motor driver integrated circuit L6470. Controlled via SPI bus.

Stepper motor driver integrated circuit TMC5130. Controlled via incremental, analog, PWM, SPI, Step / Direction, UART interfaces

Small power H-bridge

H-Bridge 6.8V/1A with Freescale MC17511A

The module uses two Freescale H-Bridges MC17511A. Power supply is 2.0-6.8V, current 1A, max 3A (per bridge). It is intended for driving small motors.

Dual H-Bridge 6.8V/2x0.7A with Freescale MC17529

The module uses dual H-Bridge made by Freescale MC17529. The power voltage is 2.0-6.8V, the current 2x0.7A, maximum current max 2x1.4A. It is intended for small motors.