Rev Author Line No. Line
3458 kaklik 1 #include <16F887.h>
2 #device adc=8
3  
4 #FUSES NOWDT //No Watch Dog Timer
5 #FUSES HS //High speed Osc (> 4mhz for PCM/PCH) (>10mhz for PCD)
6 #FUSES NOPUT //No Power Up Timer
7 #FUSES MCLR //Master Clear pin enabled
8 #FUSES NOPROTECT //Code not protected from reading
9 #FUSES NOCPD //No EE protection
10 #FUSES NOBROWNOUT //No brownout reset
11 #FUSES IESO //Internal External Switch Over mode enabled
12 #FUSES FCMEN //Fail-safe clock monitor enabled
13 #FUSES NOLVP //No low voltage prgming, B3(PIC16) or B5(PIC18) used for I/O
14 #FUSES NODEBUG //No Debug mode for ICD
15 #FUSES NOWRT //Program memory not write protected
16 #FUSES BORV40 //Brownout reset at 4.0V
17  
18 #use delay(clock=20000000)
19 #use rs232(baud=9600,parity=N,xmit=PIN_C6,rcv=PIN_C7,bits=8,errors)
20  
21 //NOTE: Must declare MASTER before SLAVE, i2c_isr_state() returns 0
22 // when MASTER is the most recent #use i2c
23 //#use i2c(MASTER, sda=PIN_C1, scl=PIN_C0, stream=I2CM)
24 #use i2c(SLAVE, Fast, sda=PIN_C4, scl=PIN_C3, force_hw, address=0xA0)
25