Problem with comparison.
| /Designs/HAM Constructions/SDRX01B/SW/timemark/main.c |
|---|
| 0,0 → 1,86 |
| #include "main.h" |
| #define LED1 PIN_E0 // RMC |
| #define LED2 PIN_E1 // 10s |
| #define LED3 PIN_E2 // PPS |
| #define LED4 PIN_A5 // Fix |
| #define SYNC_OUTPUT PIN_A0 |
| int1 sync; |
| int8 sec; |
| // Interrupt from B0 |
| #int_EXT |
| void EXT_isr(void) |
| { |
| if (sync==1) |
| { |
| output_high(SYNC_OUTPUT); |
| output_toggle(LED2); |
| delay_us(5); |
| output_low(SYNC_OUTPUT); |
| sync=0; |
| } |
| output_toggle(LED3); |
| } |
| void main() |
| { |
| setup_adc_ports(NO_ANALOGS|VSS_VDD); |
| setup_adc(ADC_CLOCK_DIV_2); |
| setup_spi(SPI_SS_DISABLED); |
| setup_timer_0(RTCC_INTERNAL|RTCC_DIV_1); |
| setup_wdt(WDT_2304MS|WDT_DIV_16); |
| setup_timer_1(T1_DISABLED); |
| setup_timer_2(T2_DISABLED,0,1); |
| setup_ccp1(CCP_OFF); |
| setup_comparator(NC_NC_NC_NC);// This device COMP currently not supported by the PICWizard |
| output_low(SYNC_OUTPUT); |
| output_high(LED1); |
| output_high(LED2); |
| output_high(LED3); |
| sync=0; |
| enable_interrupts(INT_EXT); |
| enable_interrupts(GLOBAL); |
| while(true) |
| { |
| while (getch()!='$'); |
| if (getch()!='G') continue; |
| if (getch()!='P') continue; |
| if (getch()!='R') continue; |
| if (getch()!='M') continue; |
| if (getch()!='C') continue; |
| if (getch()!=',') continue; |
| getch(); |
| getch(); |
| getch(); |
| getch(); |
| getch(); |
| output_toggle(LED1); |
| sec=getch(); |
| if ((sec=='9')) {sync=1; continue;} |
| getch(); |
| getch(); |
| getch(); |
| getch(); |
| getch(); |
| if ('A'!=getch()) |
| { |
| output_high(LED4); // Neni FIX |
| if (sec=='0') {sync=1;} // Extra click hlasi chybu |
| } |
| else |
| { |
| output_low(LED4); |
| } |
| } |
| } |