Problem with comparison.
/Designs/Laboratory_instruments/CLOCKMOT01A/CAD/CLOCKMOT01A_BOX01A/CAD/assembly.scad |
---|
0,0 → 1,53 |
use <configuration/sloupek.scad> |
use <configuration/plbase.scad> |
use <configuration/bocnice.scad> |
use <configuration/otvory.scad> |
use <configuration/text/Write.scad> |
use <upravena_bocnice.scad> |
include <configuration/manufactury_conf.scad> |
include <configuration.scad> |
include <configuration/otvory_conf.scad> |
barva_sloupku = "cyan"; |
barva_listy = "red"; |
barva_celicka = "green"; |
barva_plbase = "yellow"; |
//translate([0.5*10.16,-5.08,14]) |
// cube([10.16,10.16,10.16]); |
//BOCNICE SE DNEM |
//------------------------------------------------------------- |
upravena_bocnice(); |
//PLBASE HORNI |
//------------------------------------------------------------- |
translate([plbase_tolerance_horni-0.2,+plbase_tolerance_horni-0.2,vyska_bocnice/2-tloustka_plbase/2]) |
rotate(a=[0,0,0]) |
{ |
//plbase_vrchni_kryt(pocet_der1+2,pocet_der2+2,radidus_hrany,vzdalenost_der,vzdalenost_od_okraje,prumer_sroubu,vyska_bocnice,prekryti_der,tloustka_bocnice,plbase_tolerance_horni); |
plbase_vrchni_kryt_pro_odecet(pocet_der1-1,pocet_der2-1,radidus_hrany,vzdalenost_der,vzdalenost_od_okraje,prumer_sroubu,vyska_bocnice,prekryti_der,tloustka_bocnice,-0.2,tloustka_plbase); |
} |