| 1,27 → 1,18 |
|---|
| #include <16F887.h> |
| #include <16F88.h> |
| #device adc=8 |
| |
| #FUSES WDT //No Watch Dog Timer |
| #FUSES INTRC_IO //Internal RC Osc, no CLKOUT |
| #FUSES PUT //Power Up Timer |
| #FUSES MCLR //Master Clear pin enabled |
| #FUSES NOBROWNOUT //No brownout reset |
| #FUSES NOLVP //No low voltage prgming, B3(PIC16) or B5(PIC18) used for I/O |
| #FUSES NOCPD //No EE protection |
| #FUSES NOWRT //Program memory not write protected |
| #FUSES NODEBUG //No Debug mode for ICD |
| #FUSES NOPROTECT //Code not protected from reading |
| #FUSES NOFCMEN //Fail-safe clock monitor disabled |
| #FUSES NOIESO //Internal External Switch Over mode disabled |
| |
| |
| //#FUSES WDT // Watch Dog Timer |
| #FUSES NOWDT //No Watch Dog Timer |
| #FUSES INTRC //Internal RC Osc |
| #FUSES NOPUT //No Power Up Timer |
| #FUSES MCLR //Master Clear pin enabled |
| #FUSES NOPROTECT //Code not protected from reading |
| #FUSES NOCPD //No EE protection |
| #FUSES NOBROWNOUT //No brownout reset |
| #FUSES IESO //Internal External Switch Over mode enabled |
| #FUSES FCMEN //Fail-safe clock monitor enabled |
| #FUSES NOLVP //No low voltage prgming, B3(PIC16) or B5(PIC18) used for I/O |
| #FUSES NODEBUG //No Debug mode for ICD |
| #FUSES NOWRT //Program memory not write protected |
| #FUSES BORV40 //Brownout reset at 4.0V |
| |
| #use delay(clock=8000000) |
| |
| //set I2C |
| //#use i2c(Master,Slow,sda=PIN_C4,scl=PIN_C3) |
| |
| //set RS232 |
| #use rs232(baud=38400,parity=N,xmit=PIN_C6,rcv=PIN_C7,bits=8) |