| 34,9 → 34,9 |
|---|
| idler = 1; // Belt retainer below teeth, 0 = No, 1 = Yes |
| idler_ht = 1.5; // height of idler flange over pulley, standard = 1.5 |
| |
| pulley_t_ht = 16; // length of toothed part of pulley, standard = 12 |
| pulley_t_ht = 12.6; // length of toothed part of pulley, standard = 12 |
| pulley_b_ht = 8; // pulley base height, standard = 8. Set to same as idler_ht if you want an idler but no pulley. |
| pulley_b_dia = 20; // pulley base diameter, standard = 20 |
| pulley_b_dia = 25; // pulley base diameter, standard = 20 |
| no_of_nuts = 4; // number of captive nuts required, standard = 1 |
| nut_angle = 90; // angle between nuts, standard = 90 |
| nut_shaft_distance = 1.2; // distance between inner face of nut and shaft, can be negative. |
| 114,7 → 114,7 |
|---|
| // *** uncomment the following line if pulley is wider than puller base *** |
| // ************************************************************************ |
| |
| translate ([0,0, pulley_b_ht + pulley_t_ht + retainer_ht ]) rotate ([0,180,0]) |
| // translate ([0,0, pulley_b_ht + pulley_t_ht + retainer_ht ]) rotate ([0,180,0]) |
| |
| difference() |
| { |