| 1,3 → 1,7 |
|---|
| include <manufactury_conf.scad> |
| include <../configuration.scad> |
| use <MLAB_logo.scad> |
| |
| //Funkce pro generovani sloupku |
| module sloupek( |
| vyska, |
| 10,7 → 14,7 |
|---|
| prumer_matice, |
| vyska_matice, |
| posuv_dorazu, |
| matice_sila_materialu) { |
| matice_sila_materialu,logo_vyska,logo_sirka) { |
| |
| difference () { |
| union () { |
| 62,6 → 66,10 |
|---|
| translate([vzdalenost_der, vzdalenost_od_diry/2, -(vyska-(2*zapust))/2]) |
| linear_extrude(height = (vyska-(2*zapust))) |
| square([vzdalenost_der, vzdalenost_od_diry ], center = true); |
| |
| |
| |
| |
| } |
| |
| //diry na sroub |
| 103,5 → 111,27 |
|---|
| |
| cube([prumer_matice, prumer_matice+posuv_dorazu+vzdalenost_od_diry,vyska_matice], center = true); |
| |
| } |
| //---------------------------------------------------- |
| //LOGO MLAB |
| union (){ |
| translate ([-vzdalenost_od_okraje+1,5, 0]) // ODROIDs passive components hole. |
| rotate([0, 90, 180]) |
| scale(v = [logo_sirka, logo_vyska, 0.3]) |
| MLAB_logo_short(); |
| } |
| |
| } |
| } |
| |
| /*sloupek( |
| vyska, |
| zapust, |
| vzdalenost_der, |
| vzdalenost_od_okraje, |
| vzdalenost_od_diry, |
| radidus_hrany, |
| prumer_sroubu, |
| prumer_matice, |
| vyska_matice, |
| posuv_dorazu, |
| matice_sila_materialu); |