| 8,8 → 8,8 |
|---|
| #define LAMP1 13 // Callibration Lamp 1 |
| #define LAMP2 6 // Callibration Lamp 2 |
| #define FW1 7 // FilterWheel 1 |
| #define FW2 8 // FilterWheel 1 |
| #define FW3 3 // FilterWheel 1 |
| #define FW2 8 // FilterWheel 2 |
| #define FW3 3 // FilterWheel 3 |
| |
| const int steps = 3500; //3200; // change this to fit the number of steps |
| const int sspeed = 15; // stepper motor speed |
| 54,9 → 54,9 |
|---|
| |
| digitalWrite(LAMP1, HIGH); // All outputs OFF |
| digitalWrite(LAMP2, HIGH); |
| digitalWrite(FW1, HIGH); |
| digitalWrite(FW2, HIGH); |
| digitalWrite(FW3, HIGH); |
| digitalWrite(FW1, LOW); |
| digitalWrite(FW2, LOW); |
| digitalWrite(FW3, LOW); |
| delay(300); |
| digitalWrite(LAMP1, LOW); // blik |
| |
| 129,7 → 129,7 |
|---|
| ds.write(0x44,1); // start conversion, with parasite power on at the end |
| |
| delay(800); // maybe 750ms is enough, maybe not |
| digitalWrite(FW1, LOW); // blik |
| // digitalWrite(FW1, LOW); // blik |
| |
| present = ds.reset(); |
| ds.select(addr); |
| 158,7 → 158,7 |
|---|
| |
| // Delay for measurement, maybe 100ms is enough, maybe not |
| delay(110); |
| digitalWrite(FW2, LOW); // blik |
| // digitalWrite(FW2, LOW); // blik |
| |
| // Connect to device and set register light0 |
| Wire.beginTransmission(light0); |
| 205,7 → 205,7 |
|---|
| |
| // Delay for measurement, maybe 100ms is enough, maybe not |
| delay(110); |
| digitalWrite(FW3, LOW); // blik |
| // digitalWrite(FW3, LOW); // blik |
| |
| // Connect to device and set register light0 |
| Wire.beginTransmission(light1); |