| 19,26 → 19,22 |
|---|
| |
| /* ---------------------------- Hardware Config ---------------------------- */ |
| |
| #if! defined (__AVR_ATtiny45__) |
| #define USB_CFG_IOPORTNAME C |
| #include "config.h" |
| |
| #define USB_CFG_IOPORTNAME CONFIG_USB_PORT |
| /* This is the port where the USB bus is connected. When you configure it to |
| * "PORTB", the registers PORTB, PINB (=PORTB+2) and DDRB (=PORTB+1) will be |
| * used. |
| */ |
| #define USB_CFG_DMINUS_BIT 0 |
| #define USB_CFG_DMINUS_BIT CONFIG_USB_DMINUS |
| /* This is the bit number in USB_CFG_IOPORT where the USB D- line is connected. |
| * This MUST be bit 0. All other values will result in a compile error! |
| */ |
| #define USB_CFG_DPLUS_BIT 1 |
| #define USB_CFG_DPLUS_BIT CONFIG_USB_DPLUS |
| /* This is the bit number in USB_CFG_IOPORT where the USB D+ line is connected. |
| * This may be any bit in the port. Please note that D+ must also be connected |
| * to interrupt pin INT0! |
| */ |
| #else |
| #define USB_CFG_IOPORTNAME B |
| #define USB_CFG_DMINUS_BIT 0 |
| #define USB_CFG_DPLUS_BIT 2 |
| #endif |
| |
| /* --------------------------- Functional Range ---------------------------- */ |
| |