| 0,0 → 1,30 |
|---|
| USBasp firmware customized for MLAB hardware AVRUSB01 |
| http://www.mlab.cz/PermaLink/AVRUSB01 |
| ----------------------------------------------------- |
| |
| - original firmare from http://www.fischl.de/usbasp/usbasp.2011-05-28.tar.gz |
| - the original package contains drivers as well, please use them |
| |
| - hardware supports Green LED (always on) |
| - hardware supports Red LED (busy indicator) |
| - hardware supports jumper for slowing down SPI clocks (just install jumper on J6 to position RX-GND) |
| |
| - the code itself has to be modifyied so that it vas possible to reconfigure IO pins for |
| different hardware (minor changes in main function and in header file) |
| - make process was automated so that "make all" creates all configuraed target binaries |
| (for ATmega8 and ATmega88) |
| |
| - binary files for MLAB hardware is in bin directory |
| |
| - hardware configuration is this: |
| |
| XTAL 12.0MHz |
| USB D+ PD2/INT0 |
| USB D- PD4 |
| ISP_RES# PB2 |
| ISP_MOSI PB3 |
| ISP_MISO PB4 |
| ISP_SCK PB5 |
| GreenLED PC1 (active L) |
| RedLedLED PC0 (active L) |
| Slow SPI CLK PD0 (to GND) |