| 0,0 → 1,47 |
|---|
| #include "D:\Honza\MLAB\Modules\HumanInterfaces\TOUCHBOARD01A\SW\PIC16F887\main.h" |
| #define S_SDA PIN_C3 |
| #define S_SCL PIN_C4 |
| #use i2c(master, sda=S_SDA, scl=S_SCL) |
| #use rs232(baud=9600,parity=N,xmit=PIN_B3,rcv=PIN_B2,bits=8) //rcv TXD xmit RXD |
| |
| |
| void main() |
| { |
| |
| setup_adc_ports(NO_ANALOGS|VSS_VDD); |
| setup_adc(ADC_CLOCK_DIV_2); |
| setup_spi(SPI_SS_DISABLED); |
| setup_timer_0(RTCC_INTERNAL|RTCC_DIV_1); |
| setup_timer_1(T1_DISABLED); |
| setup_timer_2(T2_DISABLED,0,1); |
| setup_ccp1(CCP_OFF); |
| setup_comparator(NC_NC_NC_NC);// This device COMP currently not supported by the PICWizard |
| |
| printf("Simple Thermomether \r\n",); |
| |
| int STAV1; |
| unsigned int data1; |
| |
| |
| while(TRUE) |
| { |
| |
| |
| |
| //akcelerometr |
| int1 ack=0; |
| i2c_start(); // If the write command is acknowledged, |
| ack = i2c_write(0xB5);// then the device is ready. |
| i2c_stop(); |
| ack=!ack; |
| |
| |
| |
| |
| |
| |
| printf("Stav: %d (procenta)\r\n", ack); |
| //printf("Stav: %d (procenta)\r\n", STAV1); |
| delay_ms(500); |
| } |
| } |