/Modules/Mechanical/AWSCREEN01A/AMF/slic3r_config.ini
1,4 → 1,4
# generated by Slic3r 1.3.0-dev on 2016-08-30 14:13:07
# generated by Slic3r 1.3.0-dev on 2016-08-17 20:39:52
avoid_crossing_perimeters = 0
bed_shape = 0x0,180x0,180x180,0x180
bed_temperature = 50
30,11 → 30,11
fan_always_on = 1
fan_below_layer_time = 60
filament_colour = #FFFFFF
filament_diameter = 1.71
filament_diameter = 1.75
filament_settings_id =
fill_angle = 45
fill_density = 100%
fill_pattern = concentric
fill_density = 10%
fill_pattern = honeycomb
first_layer_acceleration = 500
first_layer_bed_temperature = 60
first_layer_extrusion_width = 180%
74,7 → 74,7
perimeter_extruder = 1
perimeter_extrusion_width = 0
perimeter_speed = 45
perimeters = 4
perimeters = 2
post_process =
pressure_advance = 0
print_settings_id =