| 16,6 → 16,8 |
|---|
| { |
| angle_sep = 360/D03_pocet_vyztuh; |
| |
| |
| //horni zavit |
| translate ([0,0,D03_vyska_stitu]) |
| // screen upper rim |
| difference () { |
| 22,17 → 24,17 |
|---|
| screw_thread((D03_polomer_zavitu-D03_tolerance_zavitu)*2,4,55,D03_vyska_zavitu,PI/2,2); |
| |
| translate ([0,0,-0.01]) |
| cylinder (h=D03_vyska_zavitu+0.02 ,r= D03_polomer_zavitu -D03_tolerance_zavitu- 2*D03_material_za_zavitem ,$fn=100); |
| cylinder (h=D03_vyska_zavitu+0.02 ,r= D03_polomer_zavitu -D03_tolerance_zavitu- D03_material_za_zavitem ,$fn=100); |
| } |
| |
| |
| |
| //screen |
| //screen |
| |
| difference () { |
| cylinder (h=D03_vyska_stitu,r1=D03_polomer_stitu-D03_tolerance_zavitu ,r2=D03_polomer_zavitu,$fn=100); |
| cylinder (h=D03_vyska_stitu,r1=D03_polomer_stitu ,r2=D03_polomer_zavitu,$fn=100); |
| translate ([0,0,-0.01/2]) |
| cylinder (h=D03_vyska_stitu+0.01,r1=D03_polomer_stitu-D03_tloustka_materialu ,r2=D03_polomer_zavitu -D03_tolerance_zavitu- 2*D03_material_za_zavitem,$fn=100); |
| cylinder (h=D03_vyska_stitu+0.01,r1=D03_polomer_stitu-D03_tloustka_materialu ,r2=D03_polomer_zavitu -D03_tolerance_zavitu- D03_material_za_zavitem,$fn=100); |
| |
| |
| } |
| 42,7 → 44,7 |
|---|
| |
| |
| difference () { |
| cylinder (h=D03_vyska_zavitu,r = D03_polomer_zavitu + D03_material_za_zavitem,$fn=100); |
| cylinder (h=D03_vyska_zavitu,r = D03_polomer_zavitu + D03_material_za_zavitem/2,$fn=100); |
| translate([0,0,-1]) |
| screw_thread(D03_polomer_zavitu*2,4,55,D03_vyska_zavitu+2,PI/2,2); |
| } |