| 1,9 → 1,9 |
|---|
| # generated by Slic3r 1.3.0-dev on 2016-08-30 20:09:48 |
| # generated by Slic3r 1.3.0-dev on 2016-09-02 05:15:44 |
| avoid_crossing_perimeters = 1 |
| bed_shape = 0x0,180x0,180x180,0x180 |
| bed_temperature = 50 |
| before_layer_gcode = |
| bottom_solid_layers = 3 |
| bottom_solid_layers = 5 |
| bridge_acceleration = 1000 |
| bridge_fan_speed = 100 |
| bridge_flow_ratio = 1 |
| 40,7 → 40,7 |
|---|
| first_layer_extrusion_width = 180% |
| first_layer_height = 0.3 |
| first_layer_speed = 60% |
| first_layer_temperature = 220 |
| first_layer_temperature = 215 |
| gap_fill_speed = 10 |
| gcode_arcs = 0 |
| gcode_comments = 0 |
| 52,16 → 52,16 |
|---|
| infill_first = 0 |
| infill_only_where_needed = 0 |
| infill_overlap = 15% |
| infill_speed = 60 |
| infill_speed = 50 |
| interface_shells = 0 |
| layer_gcode = |
| layer_height = 0.15 |
| max_fan_speed = 100 |
| max_print_speed = 80 |
| max_volumetric_speed = 0 |
| max_volumetric_speed = 5 |
| min_fan_speed = 100 |
| min_print_speed = 10 |
| min_skirt_length = 0 |
| min_skirt_length = 20 |
| notes = |
| nozzle_diameter = 0.4 |
| octoprint_apikey = A7268185315B4A8B9CA2C16415AC5F1F |
| 103,7 → 103,7 |
|---|
| solid_infill_every_layers = 0 |
| solid_infill_extruder = 1 |
| solid_infill_extrusion_width = 0 |
| solid_infill_speed = 55 |
| solid_infill_speed = 50 |
| spiral_vase = 0 |
| standby_temperature_delta = -5 |
| start_gcode = G28 ; home all axes\nG92 E0.0 ; reset extruder |
| 121,13 → 121,13 |
|---|
| support_material_spacing = 2.5 |
| support_material_speed = 60 |
| support_material_threshold = 0 |
| temperature = 220 |
| temperature = 215 |
| thin_walls = 1 |
| threads = 4 |
| toolchange_gcode = |
| top_infill_extrusion_width = 0 |
| top_solid_infill_speed = 50 |
| top_solid_layers = 3 |
| top_solid_layers = 5 |
| travel_speed = 130 |
| use_firmware_retraction = 0 |
| use_relative_e_distances = 1 |