| 16,7 → 16,15 |
|---|
| { |
| angle_sep = 360/D03_pocet_vyztuh; |
| |
| //spodní kruh |
| difference () { |
| cylinder (h=3*D03_tloustka_materialu,r = D03_polomer_stitu,$fn=100); |
| translate ([0,0,-0.005]) |
| cylinder (h=3*D03_tloustka_materialu+0.01,r = D03_polomer_stitu-D03_tloustka_materialu,$fn=100); |
| |
| } |
| |
| |
| //horni zavit |
| translate ([0,0,D03_vyska_stitu]) |
| // screen upper rim |
| 30,11 → 38,12 |
|---|
| |
| |
| //screen |
| |
| |
| translate ([0,0,3*D03_tloustka_materialu]) |
| difference () { |
| cylinder (h=D03_vyska_stitu,r1=D03_polomer_stitu ,r2=D03_polomer_zavitu,$fn=100); |
| cylinder (h=D03_vyska_stitu-3*D03_tloustka_materialu,r1=D03_polomer_stitu ,r2=D03_polomer_zavitu,$fn=100); |
| translate ([0,0,-0.01/2]) |
| cylinder (h=D03_vyska_stitu+0.01,r1=D03_polomer_stitu-D03_tloustka_materialu ,r2=D03_polomer_zavitu -D03_tolerance_zavitu- D03_material_za_zavitem,$fn=100); |
| cylinder (h=D03_vyska_stitu-3*D03_tloustka_materialu+0.01,r1=D03_polomer_stitu-D03_tloustka_materialu ,r2=D03_polomer_zavitu -D03_tolerance_zavitu- D03_material_za_zavitem,$fn=100); |
| |
| |
| } |
| 55,7 → 64,7 |
|---|
| rotate ([90,0,angle_sep* i]) |
| translate ([0,0,-D03_tloustka_materialu/2]) |
| linear_extrude (height = D03_tloustka_materialu, convexity = 10) |
| polygon(points=[[D03_polomer_zavitu, D03_vyska_zavitu],[D03_polomer_zavitu, 0],[D03_polomer_stitu - D03_tloustka_materialu,0],[D03_polomer_zavitu,D03_vyska_stitu]]); |
| polygon(points=[[D03_polomer_zavitu,D03_vyska_stitu],[D03_polomer_zavitu, 0],[D03_polomer_stitu - D03_tloustka_materialu,0],[D03_polomer_stitu- D03_tloustka_materialu,3*D03_tloustka_materialu]]); |
| |
| } |
| } |