| 24,8 → 24,8 |
|---|
| |
| |
| //zavit |
| translate([0,0,D01_material_pod_zavitem]) |
| screw_thread(S01_prumer_zavitu-2*D03_tolerance_zavitu,4,55,S01_vyska_komponentu_na_lozisko,PI/2,2); |
| translate([0,0,D01_material_pod_zavitem-2]) |
| screw_thread(S01_prumer_zavitu-2*D03_tolerance_zavitu,4,55,S01_vyska_komponentu_na_lozisko+5,PI/2,2); |
| |
| |
| difference() |
| 64,16 → 64,18 |
|---|
| |
| translate([0,D01_delka_tyce+S01_prumer_zavitu/2+D01_material_pred_zavitem+D02_sila_materialu+(D02_prumer_obruby)/2,D02_vyska_uchytky/2]) |
| rotate(a=[0,0,270]) |
| AWSCREEN01A_D06(D02_sila_materialu,D02_vyska_uchytky,D02_prumer_obruby,D02_delka_celeho_uchytu,D02_dotahova_vzdalenost,D02_prumer_uchytneho_sroubu); |
| AWSCREEN01A_D06_2(); |
| |
| } |
| |
| //otvor |
| translate([0,0,D01_material_pod_zavitem+S01_vyska_komponentu_na_lozisko/2]) |
| cylinder (h = S01_vyska_komponentu_na_lozisko+0.02, r=(S01_prumer_zavitu-2*D03_tolerance_zavitu-D01_material_za_zavitem)/2, center = true, $fn=100); |
| translate([0,0,D01_material_pod_zavitem-1+S01_vyska_komponentu_na_lozisko/2]) |
| cylinder (h = S01_vyska_komponentu_na_lozisko+2+0.02, r=(S01_prumer_zavitu-2*D03_tolerance_zavitu-D01_material_za_zavitem)/2, center = true, $fn=100); |
| |
| //odecet vrchního závitu aby byl rovný |
| translate([0,0,D01_material_pod_zavitem+S01_vyska_komponentu_na_lozisko]) |
| |
| |
| cylinder (h = S01_vyska_komponentu_na_lozisko+0.02, r=(S01_prumer_zavitu-2*D03_tolerance_zavitu)/2, $fn=100); |
| } |
| } |
| |