| 1,51 → 1,17 |
|---|
| $fn=40; // model faces resolution. |
| include <WINDGAUGE02A_D02.scad> |
| include <AWSBOX01A_D02_2.scad> |
| include <../configuration.scad> |
| |
| //WINDGAUGE02A_D01 //uchyt velky |
| D01_material_pod_zavitem=5; |
| D01_material_za_zavitem=3; |
| D01_material_pred_zavitem=2; |
| D01_delka_tyce=60; |
| D01_sirka_tyce=10; |
| |
| //WINDGAUGE02A_D02 //uchyt na sloup |
| D02_sila_materialu=5; |
| D02_vyska_uchytky=40; |
| D02_prumer_obruby=27; //3/4 trubka |
| D02_delka_celeho_uchytu=60; |
| D02_dotahova_vzdalenost=1.5; |
| D02_prumer_uchytneho_sroubu=4.2; |
| D02_sirka_matky=9.2; //pro M4 |
| D02_vyska_matky=3; |
| |
| |
| pocet_der1=10; |
| pocet_der2=3; |
| radidus_hrany=5; |
| vzdalenost_der=10.16; |
| vzdalenost_od_okraje=vzdalenost_der/2; |
| prumer_sroubu=3.4; |
| tloustka_plbase=2; |
| prekryti_der=-2; |
| |
| D02_vyska_boxu_pod_plbase=6; |
| D02_vyska_boxu_nad_plbase=60; |
| D02_zapusteni_spodniho_krytu=10; |
| D02_sila_materialu=1.2; |
| D02_dolerance_na_zasunuti=0.4; //tolerance je pro obě strany |
| |
| drzak_sroubu_hloubka=15; |
| drzak_sroubu_vyska=10; |
| matka_vyska=3; |
| |
| AWSBOX01A_D02(); |
| |
| module AWSBOX01A_D02(){ |
| |
| |
| |
| plbase(pocet_der1,pocet_der2,radidus_hrany,vzdalenost_der,vzdalenost_od_okraje,prumer_sroubu,tloustka_plbase,prekryti_der); |
| |
| module plbase(pocet_der1,pocet_der2,radidus_hrany,vzdalenost_der,vzdalenost_od_okraje,prumer_sroubu,tloustka_plbase,prekryti_der){ |
| |
| difference () { |
| union () { |
| |