| 1,36 → 1,23 |
|---|
| use <../configuration/plbase.scad> |
| use <../configuration/sloupek.scad> |
| use <../configuration/bocnice.scad> |
| |
| |
| |
| include <../configuration/manufactury_conf.scad> |
| include <../configuration.scad> |
| |
| |
| |
| //BOCNICE |
| //------------------------------------------------------------- |
| |
| difference () { |
| translate([0,0,(vyska_bocnice/2)+tloustka_plbase]) |
| bocnice(pocet_der1+2,pocet_der2+2,radidus_hrany,vzdalenost_der,vzdalenost_od_okraje,prumer_sroubu,vyska_bocnice,prekryti_der,tloustka_bocnice); |
| |
| translate([0,0,(vyska_bocnice/2)+tloustka_plbase]) |
| rotate(a=[90,0,0]) |
| cylinder(r=8,h=15); |
| |
| translate([0,50,(vyska_bocnice/2)]) |
| rotate(a=[0,0,0]) |
| cube([15,80,12], true); |
| |
| |
| } |
| |
| //PLBASE SPODNI |
| //------------------------------------------------------------- |
| translate([-((pocet_der2+2)*vzdalenost_der+2*vzdalenost_od_okraje)/2-tloustka_bocnice,-vzdalenost_od_okraje-tloustka_bocnice,tloustka_plbase]) |
| rotate(a=[180,0,90]) |
| |
| |
| plbase(pocet_der1+3,pocet_der2+3,radidus_hrany,vzdalenost_der,vzdalenost_od_okraje,prumer_sroubu,tloustka_plbase,prekryti_der,tloustka_bocnice); |
| use <../configuration/plbase.scad> |
| use <../configuration/sloupek.scad> |
| use <../upravena_bocnice.scad> |
| |
| |
| |
| include <../configuration/manufactury_conf.scad> |
| include <../configuration.scad> |
| |
| |
| |
| //BOCNICE |
| //------------------------------------------------------------- |
| |
| difference () { |
| translate([0,0,(vyska_bocnice/2)+tloustka_plbase]) |
| upravena_bocnice(); |
| |
| |
| |
| |
| } |
| |