| 56,7 → 56,7 |
|---|
| { |
| //závit na ukotvení rotoru |
| //zakladni material |
| cylinder (h = (S01_prumer_vnitrni/2+4*S01_sila_materialu)+R01_vyska_preryti_statoru, r=(lozisko_prumer_vnejsi/2-1), $fn=100); |
| cylinder (h = (S01_prumer_vnitrni/2+4*S01_sila_materialu)+R01_vyska_preryti_statoru, r=(lozisko_prumer_vnejsi/2-1)+2, $fn=100); |
| |
| vyztuhy(); |
| } |
| 63,12 → 63,20 |
|---|
| |
| //vnitrni zavit |
| translate([0,0,-5]) |
| screw_thread((11),3,55,R01_vyska_preryti_statoru+10,PI/2,2); |
| screw_thread((15),3,55,R01_vyska_preryti_statoru+10,PI/2,2); |
| |
| //za závitem aby to slo tisknout |
| translate([0,0,R01_vyska_preryti_statoru+5]) |
| cylinder(h=(5), r1=(11)/2, r2=0, center=false, $fn=100); |
| |
| cylinder(h=(5), r1=(15)/2, r2=0, center=false, $fn=100); |
| |
| difference() |
| { |
| translate([0,0,R01_vyska_preryti_statoru]) |
| sphere(d = (S01_prumer_vnitrni/2+5*S01_sila_materialu)*2+10, $fn=100); |
| translate([0,0,R01_vyska_preryti_statoru]) |
| sphere(d = (S01_prumer_vnitrni/2+5*S01_sila_materialu)*2, $fn=100); |
| |
| } |
| } |
| } |
| |