| 1,9 → 1,9 |
|---|
| # generated by Slic3r 1.2.8 on Tue Jun 16 17:54:14 2015 |
| avoid_crossing_perimeters = 0 |
| # generated by Slic3r 1.2.8 on Thu Jun 18 01:43:16 2015 |
| avoid_crossing_perimeters = 1 |
| bed_shape = 0x0,180x0,180x180,0x180 |
| bed_temperature = 50 |
| before_layer_gcode = |
| bottom_solid_layers = 3 |
| bottom_solid_layers = 4 |
| bridge_acceleration = 1000 |
| bridge_fan_speed = 100 |
| bridge_flow_ratio = 1 |
| 32,7 → 32,7 |
|---|
| filament_colour = #FFFFFF |
| filament_diameter = 1.75 |
| fill_angle = 45 |
| fill_density = 20% |
| fill_density = 15% |
| fill_pattern = concentric |
| first_layer_acceleration = 500 |
| first_layer_bed_temperature = 60 |
| 93,7 → 93,7 |
|---|
| slowdown_below_layer_time = 30 |
| small_perimeter_speed = 30 |
| solid_infill_below_area = 50 |
| solid_infill_every_layers = 0 |
| solid_infill_every_layers = 35 |
| solid_infill_extruder = 1 |
| solid_infill_extrusion_width = 0 |
| solid_infill_speed = 55 |