| 16,13 → 16,13 |
|---|
| #FUSES NOWRTD //Data EEPROM not write protected |
| #FUSES IESO //Internal External Switch Over mode enabled |
| #FUSES FCMEN //Fail-safe clock monitor enabled |
| #FUSES PBADEN //PORTB pins are configured as analog input channels on RESET |
| #FUSES NOPBADEN //PORTB pins are configured as analog input channels on RESET |
| #FUSES NOWRTC //configuration not registers write protected |
| #FUSES NOWRTB //Boot block not write protected |
| #FUSES NOEBTR //Memory not protected from table reads |
| #FUSES NOEBTRB //Boot block not protected from table reads |
| #FUSES NOCPB //No Boot Block code protection |
| #FUSES MCLR //Master Clear pin enabled |
| #FUSES NOMCLR //Master Clear pin disabled |
| #FUSES LPT1OSC //Timer1 configured for low-power operation |
| #FUSES NOXINST //Extended set extension and Indexed Addressing mode disabled (Legacy mode) |
| #FUSES PLL5 //Divide By 5(48MHz oscillator input) |
| 33,5 → 33,4 |
|---|
| |
| #use delay(clock=48000000) |
| #use rs232(baud=9600,parity=N,xmit=PIN_C6,rcv=PIN_C7,bits=8) |
| #use rs232(baud=9600,parity=N,xmit=PIN_C6,rcv=PIN_C7,bits=8) |
| |