| 35,8 → 35,8 |
|---|
| void EXT_isr() //interrup from rain sensor clip. |
| { |
| rain++; |
| if (input(PIN_B0)) ext_int_edge( H_TO_L ); |
| if (!input(PIN_B0)) ext_int_edge( L_TO_H ); |
| // if (input(PIN_B0)) ext_int_edge( H_TO_L ); osetreni pro pripad, ze by bylo treba cist obe hrany impulzu |
| // if (!input(PIN_B0)) ext_int_edge( L_TO_H ); |
| } |
| |
| float wind_direction(void) //vypocet azimutu smeru vetru |
| 43,7 → 43,8 |
|---|
| { |
| signed int16 X,Y,Z; |
| float b; |
| X = mag_readX(); |
| X = mag_readX(); |
| delay_ms(10); |
| Y = mag_readY(); |
| |
| |
| 84,11 → 85,6 |
|---|
| |
| unsigned int8 sht_config; |
| |
| //nastaveni SHT25 |
| SHT25_soft_reset(); |
| sht_config = SHT25_RH12_T14 | SHT25_HEATER_OFF; //vypnuti topeni v SHT25 |
| SHT25_setup(sht_config); |
| |
| //nastavení pøeruení pro anemometr |
| enable_interrupts(INT_TIMER1); |
| enable_interrupts(INT_TIMER0); |
| 100,10 → 96,15 |
|---|
| timer0_overflow_count=0; |
| rain=0; |
| |
| |
| welcome(); |
| set_mag(); //nastaveni magnetometru pro smer vetru |
| |
| //nastaveni SHT25 |
| SHT25_soft_reset(); |
| sht_config = SHT25_RH12_T14 | SHT25_HEATER_OFF; //vypnuti topeni v SHT25 |
| SHT25_setup(sht_config); |
| |
| |
| while(TRUE) |
| { |
| unsigned int32 i=0; |