| 37,6 → 37,9 |
|---|
| pinMode(FW2, OUTPUT); |
| pinMode(FW3, OUTPUT); |
| |
| pinMode(6, OUTPUT); |
| analogWrite(6, 128); |
| |
| // initialize the serial port: |
| Serial.begin(9600); |
| |
| 46,6 → 49,9 |
|---|
| |
| void loop() |
| { |
| |
| while(TRUE); |
| |
| byte i,n; // for fors |
| byte present = 0; // for 1-Wire |
| byte data[12]; // data from temperature |
| 54,9 → 60,9 |
|---|
| |
| digitalWrite(LAMP1, HIGH); // All outputs OFF |
| digitalWrite(LAMP2, HIGH); |
| digitalWrite(FW1, LOW); |
| digitalWrite(FW2, LOW); |
| digitalWrite(FW3, LOW); |
| digitalWrite(FW1, HIGH); |
| digitalWrite(FW2, HIGH); |
| digitalWrite(FW3, HIGH); |
| delay(300); |
| digitalWrite(LAMP1, LOW); // blik |
| |
| 129,7 → 135,7 |
|---|
| ds.write(0x44,1); // start conversion, with parasite power on at the end |
| |
| delay(800); // maybe 750ms is enough, maybe not |
| // digitalWrite(FW1, LOW); // blik |
| digitalWrite(FW1, LOW); // blik |
| |
| present = ds.reset(); |
| ds.select(addr); |
| 158,7 → 164,7 |
|---|
| |
| // Delay for measurement, maybe 100ms is enough, maybe not |
| delay(110); |
| // digitalWrite(FW2, LOW); // blik |
| digitalWrite(FW2, LOW); // blik |
| |
| // Connect to device and set register light0 |
| Wire.beginTransmission(light0); |
| 205,7 → 211,7 |
|---|
| |
| // Delay for measurement, maybe 100ms is enough, maybe not |
| delay(110); |
| // digitalWrite(FW3, LOW); // blik |
| digitalWrite(FW3, LOW); // blik |
| |
| // Connect to device and set register light0 |
| Wire.beginTransmission(light1); |