| 0,0 → 1,25 |
|---|
| #include <18F8310.h> |
| #device adc=8 |
| |
| #FUSES NOWDT //No Watch Dog Timer |
| #FUSES WDT128 //Watch Dog Timer uses 1:128 Postscale |
| #FUSES INTRC_IO //Internal RC Osc, no CLKOUT |
| #FUSES NOBROWNOUT //No brownout reset |
| #FUSES BORV46 //Brownout reset at 4.6V |
| #FUSES PUT //Power Up Timer |
| #FUSES BW16 //16-bit external bus mode |
| #FUSES STVREN //Stack full/underflow will cause reset |
| #FUSES NODEBUG //No Debug mode for ICD |
| #FUSES IESO //Internal External Switch Over mode enabled |
| #FUSES NOFCMEN //Fail-safe clock monitor enabled |
| #FUSES NOXINST //Extended set extension and Indexed Addressing mode disabled (Legacy mode) |
| #FUSES NOWAIT //Wait selections unavailable for Table Reads or Table Writes |
| #FUSES NOPROTECT //Code not protected from reading |
| #FUSES NOEBTR //Memory not protected from table reads |
| #FUSES LPT1OSC //Timer1 configured for low-power operation |
| #FUSES NOMCLR //Master Clear pin enabled |
| #FUSES MCU //Microcontroller Mode |
| |
| #use delay(clock=1000000) |
| #use rs232(baud=19200,parity=N,xmit=PIN_C6,rcv=PIN_C7,bits=8) |
| |