| /Designs/MRAKOMER3/SW/irmrak3.c |
|---|
| 143,10 → 143,9 |
| { |
| n++; |
| if (kbhit()) |
| if (kbhit()) // Would you like warmer? |
| { |
| delay_ms(200); |
| if ('w'==getc()) i=0; // Would you like warmer? |
| getc(); i=0; |
| } |
| tempa=ReadTemp(SA, RAM_Tamb); // Read temperatures from sensor |
| 154,7 → 153,7 |
| if((0==tempa)||(0==temp)) // Transfer error? |
| { |
| printf("%Lu;ta:-273;ts:-273;Error\n\r",n); |
| printf("%Lu;ta:-273;ts:-273;sta:-1\n\r",n); |
| output_low(HEATING); |
| } |
| else |
| 162,15 → 161,15 |
| to=(signed int16)(temp*2-27315)/100; |
| ta=(signed int16)(tempa*2-27315)/100; |
| printf("%Lu;ta:%Ld;ts:%Ld;",n,ta,to); |
| printf("%Lu;ta:%Ld;ts:%Ld;sta:",n,ta,to); |
| if (i>=MAXHEAT) |
| { |
| printf("OK\n\r"); |
| printf("0\n\r"); |
| output_low(HEATING); |
| } |
| else |
| { |
| printf("Heating\n\r"); |
| printf("1\n\r"); |
| output_high(HEATING); |
| i++; |
| } |
| /Designs/MRAKOMER3/SW/irmrak3.h |
|---|
| 15,6 → 15,6 |
| #FUSES NOIESO //Internal External Switch Over mode disabled |
| #use delay(clock=4000000) |
| #use rs232(baud=2400,parity=N,xmit=PIN_B5,rcv=PIN_B2,bits=8) |
| #use i2c(Master,Slow,sda=PIN_B1,scl=PIN_B4,SMBUS)//,force_hw) |
| #use rs232(baud=2400,parity=N,xmit=PIN_B5,rcv=PIN_B2,bits=8,FORCE_SW) |
| #use i2c(MASTER,SLOW,sda=PIN_B1,scl=PIN_B4,SMBUS)//,force_hw) |