Rev 4474 Rev 4476
Line 17... Line 17...
17   17  
18   18  
19 difference() 19 difference()
20 { 20 {
21 21
22 22
23 cylinder (h = S01_vyska_horni_zavit+S01_sila_materialu, r=(S01_prumer_vnitrni+4*S01_sila_materialu)/2+S01_tolerance_zavit/2, $fn=100); -  
-   23 union() {
24 translate([0,0,S01_sila_materialu]) 24 translate([0,0,S01_sila_materialu])
25 screw_thread((S01_prumer_vnitrni+2*S01_sila_materialu+S01_tolerance_zavit),S01_hloubka_zavitu,55,S01_vyska_horni_zavit,PI/2,2); 25 screw_thread((S01_prumer_vnitrni-S01_tolerance_zavit),S01_hloubka_zavitu,55,S01_vyska_horni_zavit,PI/2,2);
-   26
-   27 //spodní doraz
-   28
-   29 cylinder (h = S01_sila_materialu, r=S01_prumer_vnitrni/2+S01_sila_materialu, $fn=100);
-   30 }
-   31  
-   32 //odstranění vnitřní výplně
-   33 translate([0,0,S01_sila_materialu])
-   34 cylinder (h = S01_vyska_horni_zavit+0.01, r=S01_prumer_vnitrni/2-S01_hloubka_zavitu/2-S01_sila_materialu, $fn=100);
26 35
27 //otvor na pruchod hridelky 36 //otvor na pruchod hridelky
28 translate([0,0,S01_sila_materialu/2]) 37 translate([0,0,S01_sila_materialu/2])
29 cylinder (h = S01_sila_materialu+0.01, r=(lozisko_prumer_vnitrni+0.2)/2+lozisko_prekryv, center = true, $fn=100); 38 cylinder (h = S01_sila_materialu+0.01, r=(lozisko_prumer_vnitrni+0.2)/2+lozisko_prekryv, center = true, $fn=100);
30 39
Line 78... Line 87...
78 cylinder (h = lozisko_vyska+2*S01_sila_materialu+2*S01_sila_materialu+vyska_hlavy_sroubu+magnet_vyska+vyska_matky+0.01, r=(lozisko_prumer_vnejsi+0.2)/2, $fn=100); 87 cylinder (h = lozisko_vyska+2*S01_sila_materialu+2*S01_sila_materialu+vyska_hlavy_sroubu+magnet_vyska+vyska_matky+0.01, r=(lozisko_prumer_vnejsi+0.2)/2, $fn=100);
79 88
80 } 89 }
81   90  
82   91  
-   92  
-   93  
-   94  
83 } 95 }
84 } 96 }
85   97  
86   98  
87 //sloupek na senzor 99 //sloupek na senzor