Rev 3180 Rev 3275
Line 1... Line 1...
1 #include "D:\Honza\MLAB\Modules\Sensors\LTS01A\SW\PIC16F887\main.h" 1 #include "main.h"
2   2  
3 #define S_SDA PIN_C3 3 #define S_SDA PIN_C4
4 #define S_SCL PIN_C4 4 #define S_SCL PIN_C3
5 #use i2c(master, sda=S_SDA, scl=S_SCL) 5 #use i2c(master, sda=S_SDA, scl=S_SCL)
6 #use rs232(baud=9600,parity=N,xmit=PIN_B3,rcv=PIN_B2,bits=8) //rcv TXD xmit RXD 6 #use rs232(baud=9600,parity=N,xmit=PIN_C6,rcv=PIN_C7,bits=8)
7   7  
8 //Adresa pro VDD, VDD, VDD W 0x9E R 0x9F -  
9 //Adresa pro GND GND GND W 0x90 R 0x91 8 #include "../LTS01.h"
10   9  
11 void main() 10 void main()
12 { 11 {
13   12  
14 setup_adc_ports(NO_ANALOGS|VSS_VDD); 13 setup_adc_ports(NO_ANALOGS|VSS_VDD);
Line 18... Line 17...
18 setup_timer_1(T1_DISABLED); 17 setup_timer_1(T1_DISABLED);
19 setup_timer_2(T2_DISABLED,0,1); 18 setup_timer_2(T2_DISABLED,0,1);
20 setup_ccp1(CCP_OFF); 19 setup_ccp1(CCP_OFF);
21 setup_comparator(NC_NC_NC_NC);// This device COMP currently not supported by the PICWizard 20 setup_comparator(NC_NC_NC_NC);// This device COMP currently not supported by the PICWizard
22   21  
23 printf("Simple Thermomether \r\n",); 22 printf("Simple Thermomether with LTS01A sensor \r\n",);
24 printf("(c) MLAB 2013 JACHO \r\n",); 23 printf("(c) MLAB.cz 2013 JACHO \r\n",);
25   -  
26 signed int8 MSB; -  
27 byte LSB; -  
28 float t; -  
29 24
30 while(TRUE) 25 while(TRUE)
31 { 26 {
32 -  
33   -  
34   -  
35 i2c_start(); -  
36 I2C_Write(0x90); -  
37 I2C_write(0x00); -  
38 i2c_stop(); -  
39 i2c_start(); -  
40 I2C_Write(0x91); -  
41 MSB=i2c_read(1); -  
42 LSB=i2c_read(0); -  
43 i2c_stop(); -  
44 -  
45 t = (float)(LSB)/256.0; -  
46 t = (float)(MSB+t); -  
47   -  
48 printf("Teplota: %f (C)\r\n", t); 27 printf("T: %f\r\n", LTS01_get_temp());
49 delay_ms(500); 28 delay_ms(500);
50 } 29 }
51 } 30 }
52   31