use <configuration/sloupek.scad>
use <configuration/plbase.scad>
use <configuration/bocnice.scad>
use <configuration/otvory.scad>
use <configuration/text/Write.scad>


include <configuration/manufactury_conf.scad>
include <configuration.scad>
include <configuration/otvory_conf.scad>


barva_sloupku = "cyan";
barva_listy = "red";
barva_celicka = "green";
barva_plbase = "yellow";

//translate([0.5*10.16,-5.08,14])
//    cube([10.16,10.16,10.16]);  


//BOCNICE
//-------------------------------------------------------------
bocnice(pocet_der1+2,pocet_der2+2,radidus_hrany,vzdalenost_der,vzdalenost_od_okraje,prumer_sroubu,vyska_bocnice,prekryti_der,tloustka_bocnice);


//PLBASE SPODNI
//-------------------------------------------------------------
color(barva_plbase)
translate([-((pocet_der2+2)*vzdalenost_der+2*vzdalenost_od_okraje)/2-tloustka_bocnice,-vzdalenost_od_okraje-tloustka_bocnice,-(vyska_bocnice/2)])
rotate(a=[180,0,90])


plbase(pocet_der1+3,pocet_der2+3,radidus_hrany,vzdalenost_der,vzdalenost_od_okraje,prumer_sroubu,tloustka_plbase,prekryti_der,tloustka_bocnice);


//PLBASE HORNI
//-------------------------------------------------------------



translate([plbase_tolerance_horni/2,+plbase_tolerance_horni/2,vyska_bocnice/2-tloustka_plbase/2])
rotate(a=[0,0,0])
    {
        
     
  plbase_vrchni_kryt(pocet_der1+2,pocet_der2+2,radidus_hrany,vzdalenost_der,vzdalenost_od_okraje,prumer_sroubu,vyska_bocnice,prekryti_der,tloustka_bocnice,plbase_tolerance_horni);
  
        
     }