$fn=40; // model faces resolution.
include <../configuration.scad>

include <WINDGAUGE02A_D02.scad>
include <polyScrewThread_r1.scad>

PI=3.141592;



module WINDGAUGE02A_D01()
    {

difference()
        {

 union()  
   { 
       //zavit
translate([0,0,D01_material_pod_zavitem])       
 screw_thread(S01_prumer_vnitrni-S01_tolerance_zavit,4,55,S01_vyska_spodniho_zavitu,PI/2,2);            

//spodní valec
translate([0,0,D01_material_pod_zavitem/2])
cylinder (h = D01_material_pod_zavitem, r=(S01_prumer_vnitrni-S01_tolerance_zavit+D01_material_pred_zavitem*2)/2, center = true, $fn=100);

//uchyt na tyc
       translate([0,D01_delka_tyce/2+(S01_prumer_vnitrni-S01_tolerance_zavit)/2+D01_material_pred_zavitem,D01_material_pod_zavitem/2])
 cube([D01_sirka_tyce,D01_delka_tyce,D01_material_pod_zavitem],center=true); 
  

      

 
             
     
     
//uchyt na tyc ovalna cast
translate([0,(S01_prumer_vnitrni-S01_tolerance_zavit)/2+D01_material_pred_zavitem,D01_material_pod_zavitem/2])
 cube([D01_sirka_tyce,D01_material_za_zavitem+D01_material_pred_zavitem,D01_material_pod_zavitem],center=true);
       
       
//material kolem uchytu na sloupek
  translate([0,D01_delka_tyce+(S01_prumer_vnitrni-S01_tolerance_zavit)/2+D01_material_pred_zavitem+(D02_sila_materialu+D02_prumer_obruby/2)/2-D02_dotahova_vzdalenost,D01_material_pod_zavitem/2])
difference()
        {
       cube([D01_sirka_tyce,D02_sila_materialu+D02_prumer_obruby/2,D01_material_pod_zavitem],center=true);
       translate([0,D02_prumer_obruby/2-D02_dotahova_vzdalenost-D02_sila_materialu,0])    
        cylinder(h=D02_vyska_uchytky+0.01,r=D02_prumer_obruby/2,center=true);         
            
}        
            


//uchyt na sloupek
       
       translate([0,D01_delka_tyce+(S01_prumer_vnitrni-S01_tolerance_zavit)/2+D01_material_pred_zavitem+D02_sila_materialu+(D02_prumer_obruby)/2,D02_vyska_uchytky/2])
        rotate(a=[0,0,270])
 WINDGAUGE02A_D02();      

}

//otvor
translate([0,0,(D01_material_pod_zavitem+S01_vyska_spodniho_zavitu)/2])
cylinder (h = D01_material_pod_zavitem+S01_vyska_spodniho_zavitu+0.02, r=((S01_prumer_vnitrni-S01_tolerance_zavit)-2*D01_material_za_zavitem)/2, center = true, $fn=100);

 }
    }
 
WINDGAUGE02A_D01();