{HEADER END}
{FILE START}

MLAB

[/] [Designs/] [dum/] [SW/] [2patra/] [2np/] [main.h] - Revize 2085

Porovnej s předchozí - Blame - Stáhnout jako soubor

#include <18F8310.h>
#device adc=8

#FUSES NOWDT                    //No Watch Dog Timer
#FUSES WDT128                   //Watch Dog Timer uses 1:128 Postscale
#FUSES INTRC_IO                 //Internal RC Osc, no CLKOUT
#FUSES NOBROWNOUT               //No brownout reset
#FUSES BORV46                   //Brownout reset at 4.6V
#FUSES PUT                      //Power Up Timer
#FUSES BW16                     //16-bit external bus mode
#FUSES STVREN                   //Stack full/underflow will cause reset
#FUSES NODEBUG                  //No Debug mode for ICD
#FUSES IESO                     //Internal External Switch Over mode enabled
#FUSES NOFCMEN                    //Fail-safe clock monitor enabled
#FUSES NOXINST                  //Extended set extension and Indexed Addressing mode disabled (Legacy mode)
#FUSES NOWAIT                   //Wait selections unavailable for Table Reads or Table Writes
#FUSES NOPROTECT                //Code not protected from reading
#FUSES NOEBTR                   //Memory not protected from table reads
#FUSES LPT1OSC                  //Timer1 configured for low-power operation
#FUSES NOMCLR                     //Master Clear pin enabled
#FUSES MCU                      //Microcontroller Mode

#use delay(clock=8000000)
#use rs232(baud=19200,parity=N,xmit=PIN_C6,rcv=PIN_C7,bits=8)

{FILE END}
{FOOTER START}

Poháněno WebSVN v2.1 alpha 1