Subversion Repositories svnkaklik

#include <18F2550.h>

#device adc=8

#FUSES NOWDT                 	//No Watch Dog Timer

#FUSES WDT128                	//Watch Dog Timer uses 1:128 Postscale

#FUSES XT                    	//Crystal osc <= 4mhz for PCM/PCH , 3mhz to 10 mhz for PCD

#FUSES NOPROTECT             	//Code not protected from reading

#FUSES NOBROWNOUT            	//No brownout reset

#FUSES BORV20                	//Brownout reset at 2.0V

#FUSES NOPUT                 	//No Power Up Timer

#FUSES NOCPD                 	//No EE protection

#FUSES STVREN                	//Stack full/underflow will cause reset

#FUSES NODEBUG               	//No Debug mode for ICD

#FUSES NOLVP                 	//No low voltage prgming, B3(PIC16) or B5(PIC18) used for I/O

#FUSES NOWRT                 	//Program memory not write protected

#FUSES NOWRTD                	//Data EEPROM not write protected

#FUSES IESO                  	//Internal External Switch Over mode enabled

#FUSES FCMEN                 	//Fail-safe clock monitor enabled

#FUSES PBADEN                	//PORTB pins are configured as analog input channels on RESET

#FUSES NOWRTC                	//configuration not registers write protected

#FUSES NOWRTB                	//Boot block not write protected

#FUSES NOEBTR                	//Memory not protected from table reads

#FUSES NOEBTRB               	//Boot block not protected from table reads

#FUSES NOCPB                 	//No Boot Block code protection

#FUSES MCLR                  	//Master Clear pin enabled

#FUSES LPT1OSC               	//Timer1 configured for low-power operation

#FUSES NOXINST               	//Extended set extension and Indexed Addressing mode disabled (Legacy mode)

#FUSES PLL12                 	//Divide By 12(48MHz oscillator input)

#FUSES CPUDIV4               	//System Clock by 4

#FUSES USBDIV                	//USB clock source comes from PLL divide by 2

#FUSES VREGEN                	//USB voltage regulator enabled

#use delay(clock=4000000)