Subversion Repositories svnkaklik

Rev

Rev 1135 | Go to most recent revision | Details | Compare with Previous | Last modification | View Log

Rev Author Line No. Line
1096 kaklik 1
\chap Conclusion 
2
 
1134 fluktuacia 3
A special design of scalable data-acquisition system was proposed. This system has unique parameters compared to the state of the art radioastronomy signal processing hardware. Offering a 16bit resolution and comparable dynamical range is more than other similar constructions could offer.  We demonstrated system functionality on the most basic interferometric station. Further validation of reached parameters would be necessary. Following that, the final design will eventually become a part of MLAB Advanced Radio Astronomy System\cite[mlab-aras]. 
1096 kaklik 4
 
1165 fluktuacia 5
All requirements demanded by the thesis specification have been reached or exceed. The required minimal sampling frequency of 1 MHz has been exceeded five times at least. Requested dynamical range specified by 12 bit have been exceeded at least by 8 dB in the decibel scale. As a by-pass product of digitalisation unit design the software defined GPS disciplined oscillator device has been developed. This device is currently in use on several radio meteor detection stations in Czech Republic.
6
On other hand the proposed design is not still perfect and some minor imperfections should be corrected in the future work. 
1125 kaklik 7
 
1116 kaklik 8
\sec Possible hardware improvements
1096 kaklik 9
 
1165 fluktuacia 10
The PCB design of the used modules might need more precise high-speed optimization of differential pairs. Improvement in high-speed routing allows a possible use of the fastest ADC from the Linear Technology devices family. The use of faster ADCs even improves a range of possible usages.  Minor ADC module imperfections, such as the unnecessary separation of FRAME and DCO signal to two connectors, should be mitigated. These two signals should be merged together to one SATA connector. With this modification we will be able to remove one redundant SATA cable between the analog to digital converter device and computational unit section. 
1116 kaklik 11
 
12
\sec Possible software improvements
13
 
1132 kaklik 14
In the future versions of the system hardware, the Xillybus IP core and driver interface should be swapped with an open-source alternative of PCIe interfacing module or PCIe might be completely avoided. In ADC configuration FPGA module, the SPI configuration data registers read back should be implemented. 
1116 kaklik 15
 
1135 kaklik 16
\nonum \chap Glossary 
17
 
18
\makeglos
19
 
1111 kaklik 20
\bibchap
21
\usebbl/c mybase
22