| 83,9 → 83,8 |
|---|
| void led_blink() |
| { |
| digitalWrite(3, HIGH); // set the LED on |
| delay(500); |
| delay(100); |
| digitalWrite(3, LOW); // set the LED off |
| delay(500); |
| } |
| |
| /*int light_sensor_write( unsigned int data, unsigned int address) |
| 213,14 → 212,16 |
|---|
| float luxIR=0; |
| float time; |
| |
| set_light_sensor(LIGHT_ENABLE, LIGHT_ONETIME, LIGHT_SENSE_VIS, LIGHT_INTERNAL_16, LIGHT_RANGE2); //setup sensor for visible measuring |
| set_light_sensor(LIGHT_ENABLE, LIGHT_ONETIME, LIGHT_SENSE_VIS, LIGHT_INTERNAL_16, LIGHT_RANGE1); //setup sensor for visible measuring |
| led_blink(); // Delay for measurement |
| delay(500); |
| luxVIS=get_light_measurement(); |
| |
| time=millis()/1000.0; |
| |
| set_light_sensor(LIGHT_ENABLE, LIGHT_ONETIME, LIGHT_SENSE_IR, LIGHT_INTERNAL_16, LIGHT_RANGE2); // setup sensor for infrared measuring |
| set_light_sensor(LIGHT_ENABLE, LIGHT_ONETIME, LIGHT_SENSE_IR, LIGHT_INTERNAL_16, LIGHT_RANGE1); // setup sensor for infrared measuring |
| led_blink(); // Delay for measurement |
| delay(500); |
| luxIR=get_light_measurement(); |
| |
| // open the file. note that only one file can be open at a time, |
| 250,5 → 251,6 |
|---|
| Serial.print("error opening "); |
| Serial.println(filename); |
| } |
| delay(2000); |
| } |
| |