| 0,0 → 1,35 |
|---|
| #include <18F4550.h> |
| #device adc=8 |
| |
| #FUSES NOWDT //No Watch Dog Timer |
| #FUSES WDT128 //Watch Dog Timer uses 1:128 Postscale |
| #FUSES HSPLL //High Speed Crystal/Resonator with PLL enabled |
| #FUSES NOPROTECT //Code not protected from reading |
| #FUSES NOBROWNOUT //No brownout reset |
| #FUSES BORV20 //Brownout reset at 2.0V |
| #FUSES NOPUT //No Power Up Timer |
| #FUSES NOCPD //No EE protection |
| #FUSES STVREN //Stack full/underflow will cause reset |
| #FUSES NODEBUG //No Debug mode for ICD |
| #FUSES NOLVP //No low voltage prgming, B3(PIC16) or B5(PIC18) used for I/O |
| #FUSES NOWRT //Program memory not write protected |
| #FUSES NOWRTD //Data EEPROM not write protected |
| #FUSES IESO //Internal External Switch Over mode enabled |
| #FUSES FCMEN //Fail-safe clock monitor enabled |
| #FUSES PBADEN //PORTB pins are configured as analog input channels on RESET |
| #FUSES NOWRTC //configuration not registers write protected |
| #FUSES NOWRTB //Boot block not write protected |
| #FUSES NOEBTR //Memory not protected from table reads |
| #FUSES NOEBTRB //Boot block not protected from table reads |
| #FUSES NOCPB //No Boot Block code protection |
| #FUSES MCLR //Master Clear pin enabled |
| #FUSES LPT1OSC //Timer1 configured for low-power operation |
| #FUSES NOXINST //Extended set extension and Indexed Addressing mode disabled (Legacy mode) |
| #FUSES PLL5 //Divide By 5(20MHz oscillator input) |
| #FUSES CPUDIV1 //No System Clock Postscaler |
| #FUSES USBDIV //USB clock source comes from PLL divide by 2 |
| #FUSES VREGEN //USB voltage regulator enabled |
| #FUSES ICPRT //ICPRT enabled |
| |
| #use delay(clock=20000000) |
| |