| 1,19 → 1,27 |
|---|
| #include <16F88.h> |
| #device adc=8 |
| #include "geiger.h" |
| |
| #FUSES NOWDT //No Watch Dog Timer |
| #FUSES HS //High speed Osc (> 4mhz) |
| #FUSES NOPUT //No Power Up Timer |
| #FUSES MCLR //Master Clear pin enabled |
| #FUSES NOBROWNOUT //No brownout reset |
| #FUSES NOLVP //No low voltage prgming, B3(PIC16) or B5(PIC18) used for I/O |
| #FUSES NOCPD //No EE protection |
| #FUSES NOWRT //Program memory not write protected |
| #FUSES NODEBUG //No Debug mode for ICD |
| #FUSES NOPROTECT //Code not protected from reading |
| #FUSES NOFCMEN //Fail-safe clock monitor disabled |
| #FUSES NOIESO //Internal External Switch Over mode enabled |
| |
| #use delay(clock=20000000) |
| #use rs232(baud=9600,parity=N,xmit=PIN_B3,rcv=PIN_B5,bits=8) |
| void main() |
| { |
| unsigned int16 n; |
| |
| setup_adc_ports(NO_ANALOGS|VSS_VDD); |
| setup_adc(ADC_OFF); |
| setup_spi(FALSE); |
| setup_timer_0(RTCC_EXT_H_TO_L|RTCC_DIV_1); |
| setup_timer_1(T1_DISABLED|T1_DIV_BY_1); |
| setup_timer_2(T2_DISABLED,0,1); |
| setup_ccp1(CCP_OFF); |
| setup_comparator(A0_A2_A1_A2_OUT_ON_A3_A4); |
| setup_vref(VREF_LOW|1|VREF_A2); |
| setup_oscillator(False); |
| |
| n=0; |
| set_timer0(0); |
| While(true) |
| { |
| printf("%Lu0, %u\n\r", n++, get_timer0()); |
| set_timer0(0); |
| Delay_ms(10000); |
| } |
| } |