#include "C:\Users\Honza\Documents\pic\I2C_klavesnice\main.h"

//For AKCE
//ADRESA pro èteni 0x39
//pro zápis 0x38



#include "C:\Users\Honza\Documents\pic\I2C_akcelerometr\main.h"
#define EEPROM_SDA  PIN_B0
#define EEPROM_SCL  PIN_B1
#use i2c(master, sda=EEPROM_SDA, scl=EEPROM_SCL)
#use rs232(baud=9600,parity=N,xmit=PIN_B3,rcv=PIN_B2,bits=8) //rcv TXD xmit RXD


void main()
{

   setup_adc_ports(NO_ANALOGS|VSS_VDD);
   setup_adc(ADC_CLOCK_DIV_2);
   setup_spi(SPI_SS_DISABLED);
   setup_timer_0(RTCC_INTERNAL|RTCC_DIV_1);
   setup_timer_1(T1_DISABLED);
   setup_timer_2(T2_DISABLED,0,1);
   setup_ccp1(CCP_OFF);
   setup_comparator(NC_NC_NC_NC);// This device COMP currently not supported by the PICWizard

printf("Simple Thermomether  \r\n",);

int16 data1, data2, data3;
signed int16 X, Y, Z;

unsigned int8 XL,XH,YL,YH,ZL,ZH;


  while(TRUE)
 { 

data1=0;
data2=0 ;


//akcelerometr
   int1 ack;
   i2c_start();            // If the write command is acknowledged,
   ack = i2c_write(0xB4);//hen the device is ready.
   i2c_stop();
  ack=!ack;
   
   
   
   i2c_stop();

   i2c_start();
   I2C_Write(0xB5);
   I2C_write(0x04);
// i2c_stop();
   i2c_start();
   I2C_Write(0xB4);
 XH=i2c_read(0);
   i2c_stop(); 


printf("Stav: %d (procenta)\r\n", ack);

printf("Stavx: %Ld(procenta)\r\n", X);
printf("Stavy: %Ld(procenta)\r\n", Y);
printf("Stavz: %Ld(procenta)\r\n", Z);

delay_ms (2000);

 } 
}