?lang_form?
?lang_select?
?lang_submit?
?lang_endform?
{HEADER END}
{FILE START}
library
?curdirlinks? - Rev 6
?prevdifflink? - Blame - ?getfile?
/*! \file rtl8019conf.h \brief Realtek RTL8019AS Ethernet Interface Driver Configuration. */
//*****************************************************************************
//
// File Name : 'rtl8019conf.h'
// Title : Realtek RTL8019AS Ethernet Interface Driver Configuration
// Author : Pascal Stang
// Created : 10/5/2004
// Revised : 8/22/2005
// Version : 0.1
// Target MCU : Atmel AVR series
// Editor Tabs : 4
//
// Description : This driver provides initialization and transmit/receive
// functions for the RTL8019AS 10Mb Ethernet Controller and PHY.
//
// This code is distributed under the GNU Public License
// which can be found at http://www.gnu.org/licenses/gpl.txt
//
//*****************************************************************************
#ifndef RTL8019CONF_H
#define RTL8019CONF_H
// This driver supports an RTL8019 connected in memory-mapped or direct I/O mode.
//
#define GENERAL_IO 0
// Direct I/O mode assumes the NIC address, data, and control lines are
// connected directly to processor I/O pins. The memory-bus accesses are
// software emulated.
//
#define MEMORY_MAPPED 1
// Memory-mapped mode assumes that the NIC is connected the processor via
// the external memory bus, and that the NIC address space starts at the
// memory location RTL8019_MEMORY_MAPPED_OFFSET.
//
// In either mode, a seperate I/O pins is required for control of the NIC's
// hardware RESET line.
// set the connection type used to communicate with the NIC
#define NIC_CONNECTION GENERAL_IO
#if NIC_CONNECTION != GENERAL_IO
// NIC is memory-mapped starting at this address
#define RTL8019_MEMORY_MAPPED_OFFSET 0x8000
#else // NIC Interface through General I/O
// RTL8019 address port
#define RTL8019_ADDRESS_PORT PORTB
#define RTL8019_ADDRESS_DDR DDRB
#define RTL8019_ADDRESS_MASK 0x1F
// RTL8019 data port
#define RTL8019_DATA_PORT PORTA
#define RTL8019_DATA_DDR DDRA
#define RTL8019_DATA_PIN PINA
// RTL8019 control port
#define RTL8019_CONTROL_PORT PORTD
#define RTL8019_CONTROL_DDR DDRD
#define RTL8019_CONTROL_READPIN 6
#define RTL8019_CONTROL_WRITEPIN 7
#endif
// RTL8019 RESET pin
#define RTL8019_RESET_PORT PORTD
#define RTL8019_RESET_DDR DDRD
#define RTL8019_RESET_PIN 4
// MAC address for this interface
#ifdef ETHADDR0
#define RTL8019_MAC0 ETHADDR0
#define RTL8019_MAC1 ETHADDR1
#define RTL8019_MAC2 ETHADDR2
#define RTL8019_MAC3 ETHADDR3
#define RTL8019_MAC4 ETHADDR4
#define RTL8019_MAC5 ETHADDR5
#else
#define RTL8019_MAC0 '0'
#define RTL8019_MAC1 'F'
#define RTL8019_MAC2 'F'
#define RTL8019_MAC3 'I'
#define RTL8019_MAC4 'C'
#define RTL8019_MAC5 'E'
#endif
#endif
|
{FILE END}
{FOOTER START}
Powered by WebSVN v2.8.3